All data is for information only------(Home)
PRODUCT DATA of Inconel 600
MaterialInconel 600
Product DatasheetInconel alloy 600
General InformationInconel 600 is a corrosion- and heat-resistant nickel-base alloy used for low-stressed parts operating up to 1150C. It is not hardenable except by cold working and is usually used in the annealed condition. Inconel 600 is available in all the usual mill forms.
Chemical Composition6-10Fe, 14.7-17Cr, 0.15C, rem Ni
Name of ManufacturerSpecial Metals Wiggin Ltd
Hereford, England
+44 (0)1432 382200
+44 (0)1432 264030
info@specialmetalswiggin.co.uk
EXPERIENCE IN PRACTICE
Development StatusCommercial Product
Equivalent DesignationsASTM B-166, LN 2.4640, 2.4816, NiCr15Fe
Space ExperienceGood
PHYSICAL PROPERTIES
Specific Gravity8.42
Magnetic PropertiesNonmagnetic
Curie Temperature-124 °C
Relative Permeability1.01
ELASTIC PROPERTIES
Tensile Modulus214 GPa
Shear Modulus80.8 GPa
Poisson Ratio0.324
ELECTRICAL PROPERTIES
Electrical Volume Resistivity0.00000103 ohm.m
THERMAL PROPERTIES
Thermal Conductivity14.9 W/m.K
Data Quality: Manufacturer's data
Thermal Expansion Coefficient13.3 μstrain/°C
Data Quality: Manufacturer's data
Specific Heat0.461 J/g.K
Melting Range1370 to 1430 °C
RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY
General Corrosion StatusNo specific corrosion protection required
Corrosion/ThermalThe alloy does not embrittle after long exposure at high temperatures. Contact with sulfur-containing atmospheres at elevated temperatures should be avoided
Atmospheric CorrosionThe alloy will remain bright indefinitely in indoor atmospheres
Stress Corrosion StatusHigh Resistance to SCC: Table 1
Remark:In annealed state, including weldments
Data Quality: Design Data
Bimetallic CorrosionCan be connected without any restriction to: 400 series Stainless steel
Can be connected in a non-controlled environment to the above and 300 series stainless steel, Ti and Ti-alloys, Cr, Cu, brasses, Cu-Ni, Al-bronzes, Si-bronzes,
Can be connected in a clean room environment to above and Ag, SnPb alloys, Sn, Pb, low C steel, Al-Cu alloys, Cd, Au
Needs specific measures: All others
Test:ECSS-Q-ST-70C Rev.1 Table 5.1
Data Quality: Design Data